SMATE200A – Rohde & Schwarz Signal Generators
6.00GHz (Frequency Range Max.)
The R&S SMATE200A is based on the successful R&S SMU200A but is specifically designed to meet production requirements. It comes without a display or keys on the front panel, and its connectors are located at the rear. In addition, it is optimized for faster setting times in order to reduce test time.
•Very short setting times for frequency and level (<3 ms) In List mode, setting time reduced down to <400 µs through use of predefined frequency and level values •Flexibly addressable Fast Hop mode with setting times same as in List mode •Multisegment waveform function enables fast switching between different test signals in baseband •Electronic attenuator for entire frequency and level range •Status LEDs on front, connectors on rear† •Very low SSB phase noise of typ. 135 dBc, or typ. 140 dBc with the Low Phase Noise option (20 kHz carrier offset, f = 1 GHz, 1 Hz measurement bandwidth) •Wideband noise of typ. 153 dBc (>5 MHz carrier offset, f = 1 GHz, 1 Hz measurement bandwidth)
•High output power of typ. +26 dBm with High-Power Output option
•Very high level repeatability of typ. 0.05 dB
•I/Q modulator with 200 MHz system bandwidth
•Excellent ACLR performance of typ. +70 dB with 3GPP FDD†
•Up to two complete independent signal generators in one unit
•Choice of 3 GHz and 6 GHz frequency options in both paths
•Up to two independent baseband sources that not only support realtime signal generation but also offer arbitrary waveform generation with up to 64 Msamples each†
•Digital Standard Eutra/LTE available
•Remote-controllable via LAN (Gigabit Ethernet) and GPIB

Specifications

Frequency Range Max.

6.00GHz

Freq. Resolution

10.0mHz

Output Power

+26 dBm

Modulation

AM, FM, Pulse, Phase, FSK, Vector, Wideband AM, ASK

More Details

Vector Signal Generator