DLM Series – 3 kW – Sorensen Power Supplies
600.0V (Max. Voltage)
The DLM 3 kW and 4 kW Series programmable DC power supplies are designed to provide highly stable, continuously variable output voltage and current for a broad range of applications in a compact 2U ( 3_ high) chassis.
The 4 kW power rating is new to the Sorensen Family of power supplies. Both the 3 kW and 4 kW models have output voltages from 0-5 VDC to 0-600 VDC and a current range from 0-5A to 0-450A. The output RMS noise is as low as 10 mV. The output will recover to 1% of its steady-state voltage within 1 ms for a step load change of 100% to 70% or 70% to 100%. The front panel layout makes the series extremely easy to use. Control switches include: power on, enable/ standby and local/remote.
Displays and indicators show programmed set points and operational control status. The programmed voltage, current and overvoltage set points are displayed with two large 3_ digit LED displays. Operational Status LEDs indicate power on, shutdown, overtemperature, overvoltage, constant current and voltage mode status. Control Status LEDs indicate front panel lockout, remote control and standby status. IEEE-488.2 control LEDs indicate error, service request and remote address status.
The 3 kW Models will accept 200*/230 VAC single phase and 200*/208 VAC three phase input power.
The DLM 3kW Series includes the following models:
DLM 5-350E
DLM 8-350E
DLM 16-185E
DLM 32-95E
DLM 40-75E
DLM 60-50E
DLM 80-37E
DLM 150-20E
DLM 300-10E
DLM 600-5E
The 4 kW Models will accept 200/208 VAC, three phase or optional 400 or
480 VAC three phase input power.
High Power Density – 3 kW and 4 kW models, 2U (3_ inches) high, 19 inches wide; no top or bottom clearance spacing required
Wide Range of Output Voltages – 3 kW and 4 kW outputs 0-5V, 8V, 16V, 32V, 40V, 60V, 80V, 150V, 300V and 600V
Preview Pushbutton – Overvoltage protection (OVP), voltage and current preview buttons allow viewing these set points at any time with or without the output enabled
Remote Voltage Sense – Sense leads are easily connected to a solderless connector
Remote Operation
Standard analog programming
Output enable/disable remotely
Optional IEEE-488.2 and RS 232†
Optional optically isolated analog programming
Calibration – All models can be calibrated without removing the covers
Operating Modes – Constant voltage and constant current, with LED indicators
Parallel or Series Operation – Field configurable
Input Power Factor – 0.95 typical (three phase for all models) 0.98 typical (single phase)
CE Mark, UL and C-UL Listing Mark
5 Year Warranty
Specifications
Max. Voltage
600.0V
Number of Outputs
Single
Max. Current
350.00A
More Details
Programmable DC Power Supplies